LugerForum Discussion Forums - View Single Post

Johnny Peppers · 01-26-2002, 11:35 PM

Bill,

I find that the four smaller washers are not actually domed on my rig, but are more flat with the center countersunk to allow the flat head screw to tighten up flush. The large washer is flat in the center section and then tapers to a sharp edge so as not to catch on anything.

The four small screws have a head diameter that ranges from .204 to .212, and the washers range from .396 to .399. The small screws showed remains of being fire blued on the threads, so the bright finish may have been from wear. The large screw has a slightly domed head and measures .270 in diameter, and the steel washer measures .575.

I can try a scan if you think it would help.

01-26-2002, 11:35 PM	#2
Johnny Peppers User Join Date: Jun 2002 Location: Calion, Arkansas Posts: 1,042 Thanks: 0 Thanked 1 Time in 1 Post	Re: LP08 Stock Screws Bill, I find that the four smaller washers are not actually domed on my rig, but are more flat with the center countersunk to allow the flat head screw to tighten up flush. The large washer is flat in the center section and then tapers to a sharp edge so as not to catch on anything. The four small screws have a head diameter that ranges from .204 to .212, and the washers range from .396 to .399. The small screws showed remains of being fire blued on the threads, so the bright finish may have been from wear. The large screw has a slightly domed head and measures .270 in diameter, and the steel washer measures .575. I can try a scan if you think it would help.