LugerForum Discussion Forums - View Single Post

alanint · 10-04-2009, 08:17 PM

I have had good luck in improving shooter trigger pulls by adding a bit of JB Weld to the top pad of the trigger bar, thus tightening up the tolerance between it and the sear. Add a bead, let it dry then reassemble. If it is too much and the pistol binds, file away a bit of the Weld and keep trying until you get a pull that is acceptable. When you file, make sure to "ramp" the bead from the rear so the sear flows over it when returning to battery.

10-04-2009, 08:17 PM	#5
alanint User Join Date: Mar 2008 Location: Marco Island, Florida Posts: 4,867 Thanks: 1,685 Thanked 1,917 Times in 1,193 Posts	I have had good luck in improving shooter trigger pulls by adding a bit of JB Weld to the top pad of the trigger bar, thus tightening up the tolerance between it and the sear. Add a bead, let it dry then reassemble. If it is too much and the pistol binds, file away a bit of the Weld and keep trying until you get a pull that is acceptable. When you file, make sure to "ramp" the bead from the rear so the sear flows over it when returning to battery.