LugerForum Discussion Forums - View Single Post

Edward Tinker · 09-30-2009, 09:50 PM

Charlie, not sure what HTH means.

In millimeters is how I measure and is how it states in the original specifications.

An original tool should measure 2.5 mm in thickness and under 3mm.

An unmarked I used to always think was a DWM tool, but evidently Mauser also made many tools that were unmarked.

Ed

09-30-2009, 09:50 PM	#4
Edward Tinker Super Moderator Eternal Lifer LugerForum Patron Join Date: Jun 2002 Location: North of Spokane, WA Posts: 15,974 Thanks: 2,072 Thanked 4,609 Times in 2,123 Posts	Charlie, not sure what HTH means. In millimeters is how I measure and is how it states in the original specifications. An original tool should measure 2.5 mm in thickness and under 3mm. An unmarked I used to always think was a DWM tool, but evidently Mauser also made many tools that were unmarked. Ed __________________ Edward Tinker ************ Co-Author of Police Lugers - Co-Author of Simson Lugers Author of Veteran Bring Backs Vol I, Vol II, Vol III and Vol IV