Thanks for that gentlemen. I think I found a couple hammers in Australia. I've still got a few weeks here in Thailand before I go home. I should have the hammers by then. I was thinking that I would epoxy the bar to the hammer at first. This should be strong enough to test it out and if it's in the wrong position or wrong shape I can knock it off and start again. After I get it set and working, I'll get it welded on.
It's a funny situation with the law. I can have the regular set up in normal situations. I just need these modifications to get them released from Customs. All they care about is if it meets certain criteria, then they wash their hands of them. After that happens I can put the original hammers back in.......Chip
|