Thanks for the reply. Unfortunately, their only idea of deactivating is to weld them up.
I think I've located a couple hammers. Alvin you mentioned that A little bit steel has to be added to the hammer to make the profile bigger at appropriate position and then mill a new notch on it.
Any idea how much of a plate needs to be added, and would the hammer go past this back to the fired position when you dropped the hammer.
If I can't get something sorted mechanically, my only option left is to see my Federal Member of Parliament and ask them to try to get me special dispensation from the Customs Minister. As you know, once you mention firearms, most politicians shut up shop.
If I can get two to pass, I can get them home, take out the hammers and put them into the remaining two.
Thanks again......Chip
|