LugerForum Discussion Forums - View Single Post

Don · 12-06-2001, 01:46 AM

I'm messing around with several WWI era mags and assorted wood bottoms. I'm trying to swap out a couple of bottoms, but I'm finding that apparently the dimensions are off just a fraction. I can't get the pins to line up with the holes on both sides of the mag. Anybody have any suggestions?

Also, I've acquired a couple of GT bottoms that haven't been drilled -- I guess that's more evidence that these babies need a custom fit. So do I insert em in the mag and use the holes to guide my drill bit?

Thanks, guys (and gals).

12-06-2001, 01:46 AM	#1
Don User Join Date: Jun 2002 Location: Texas Posts: 146 Thanks: 0 Thanked 0 Times in 0 Posts	Wood Magazine Bottoms I'm messing around with several WWI era mags and assorted wood bottoms. I'm trying to swap out a couple of bottoms, but I'm finding that apparently the dimensions are off just a fraction. I can't get the pins to line up with the holes on both sides of the mag. Anybody have any suggestions? Also, I've acquired a couple of GT bottoms that haven't been drilled -- I guess that's more evidence that these babies need a custom fit. So do I insert em in the mag and use the holes to guide my drill bit? Thanks, guys (and gals).