LugerForum Discussion Forums - View Single Post - Luger stock lugs

Ron Wood · 05-10-2009, 01:45 AM

Alf,
This has been a frequenly asked question. There have been lots of "reasons" given ranging from "the machinery was set up to product that type of frame, so they never bothered to change it" to "it was used in later production as a means to fasten the frame in a jig for subsequent machining operations". The truth is, nobody really knows, but it is nontheless a fact that no 4-inch barreled Lugers were issued with a shoulder stock (at least not in Germany).

05-10-2009, 01:45 AM	#11
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,035 Thanks: 1,106 Thanked 5,242 Times in 1,719 Posts	Alf, This has been a frequenly asked question. There have been lots of "reasons" given ranging from "the machinery was set up to product that type of frame, so they never bothered to change it" to "it was used in later production as a means to fasten the frame in a jig for subsequent machining operations". The truth is, nobody really knows, but it is nontheless a fact that no 4-inch barreled Lugers were issued with a shoulder stock (at least not in Germany). __________________ If it's made after 1918...it's a reproduction