LugerForum Discussion Forums - View Single Post

sheepherder · 04-28-2009, 11:40 PM

I'm concerned that my latest purchase might have a broken sear spring/hammer pivot...This is an M1930 (stepped barrel)...

I need a pic of the lockwork as it comes out of the receiver, showing the right side, where the sear spring engages the lock frame stop...

I think the tip might be broken off...

When the hammer is cocked, the lock frame stop is "floppy"...You can pull the lockwork right out - there's no spring pressure on the lock frame stop when the hammer is cocked...

Thanks in advance!

04-28-2009, 11:40 PM	#1
sheepherder Lifer Lifetime Forum Patron Join Date: Feb 2009 Location: ...on the 'ol Erie Canal... Posts: 8,197 Thanks: 1,416 Thanked 4,462 Times in 2,336 Posts	Need Pic of Broomhandle Lockwork I'm concerned that my latest purchase might have a broken sear spring/hammer pivot...This is an M1930 (stepped barrel)... I need a pic of the lockwork as it comes out of the receiver, showing the right side, where the sear spring engages the lock frame stop... I think the tip might be broken off... When the hammer is cocked, the lock frame stop is "floppy"...You can pull the lockwork right out - there's no spring pressure on the lock frame stop when the hammer is cocked... Thanks in advance!