LugerForum Discussion Forums - View Single Post - Rear Toggle Assembly

lugerholsterrepair · 04-05-2009, 07:47 PM

Bob, This pin is so small it is often difficult to get a good lick in on it without the proper drift. There was some mention on another thread that it might be swelled on one end. In other words it may drift out one way but not the other. I would think it might be extremely difficult to drill out too..Perhaps a genuine gunsmith like Howard (PoliceLuger) will come on with some suggestions.
Have you tried any penetrating oils?

Jerry Burney

04-05-2009, 07:47 PM	#2
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,134 Times in 1,439 Posts	Bob, This pin is so small it is often difficult to get a good lick in on it without the proper drift. There was some mention on another thread that it might be swelled on one end. In other words it may drift out one way but not the other. I would think it might be extremely difficult to drill out too..Perhaps a genuine gunsmith like Howard (PoliceLuger) will come on with some suggestions. Have you tried any penetrating oils? Jerry Burney __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."