LugerForum Discussion Forums - View Single Post

Chris from Minnesota · 03-09-2009, 10:36 PM

Ok here goes, I have a byf 41 ser# 4939 block p. It is all matching as far as I can see all parts with numbers match along with the grips. The bore is in excellent condition there is some light pitting on the barrel and some frost on the out side end of the bore and a small spot of pitting on the lower right corner of the side plate.

Needed some TLC, a cleaning and good oiling down. Was wounder what info there is and a value. The mag are not correct for this gun and the loading pin on the wood bottom mag has been replace with a screw is there anything that can be done with replacing the screw with an original pin. Also what are your thoughts on refurbishing the grip panels.

Thanks,
Chris From Minnesota

03-09-2009, 10:36 PM	#1
Chris from Minnesota User Join Date: Feb 2009 Posts: 58 Thanks: 3 Thanked 1 Time in 1 Post	First Luger for First timer Ok here goes, I have a byf 41 ser# 4939 block p. It is all matching as far as I can see all parts with numbers match along with the grips. The bore is in excellent condition there is some light pitting on the barrel and some frost on the out side end of the bore and a small spot of pitting on the lower right corner of the side plate. Needed some TLC, a cleaning and good oiling down. Was wounder what info there is and a value. The mag are not correct for this gun and the loading pin on the wood bottom mag has been replace with a screw is there anything that can be done with replacing the screw with an original pin. Also what are your thoughts on refurbishing the grip panels. Thanks, Chris From Minnesota Attached Thumbnails Last edited by Chris from Minnesota; 03-10-2009 at 12:43 AM.