Vlim,
thanks !!! for the excellent pictures and info
so it looks like all that is needed is just to cut off the palm safety and stub to it from the internal bar part - almost too easy
should be a lot easier than adapting the frame slot to a dwm P08 sear bar block
and I suppose one could cut the palm part off and polish the metal + blue to fill / match up with the grip slot when in safe position
mine has the grip pins and is P08 type frame - so far about 200 rounds with a few eject problems
now if I can resolve the rear target sight and bull barrel problem , could finally have a simulated target MP
rear target sight and barrel ( long barrel extension type ) seem to be elusive problems to resolve here in usa
have you seen any of the Rettinger in Germany made target lugers ?
thanks again for the info
Bill
|