View Single Post
Unread 01-07-2009, 04:04 PM   #3
bergwerk
User
 
bergwerk's Avatar
 
Join Date: Nov 2008
Location: north
Posts: 59
Thanks: 16
Thanked 0 Times in 0 Posts
Default locking lever grooves

i know its asking a lot but would anyone have a good pic of these grooves as that may be my problem , on my lever i have a defined groove undernreth the locating slot part which runs almost the full length of the shaft ,but the second groove is smaller and in the centre area of the shaft . is that right ?
bergwerk is offline   Reply With Quote