View Single Post
Unread 12-14-2008, 11:30 AM   #9
jonnyc
User
 
Join Date: Dec 2008
Posts: 425
Thanks: 2
Thanked 46 Times in 34 Posts
Default

So far that hasn't been an issue, since the locking bolt is still VERY tight. Better fitting and a spring are in the plan.

Good news and bad news on today's range session.
1. All three types of ammo cycled perfectly. I'm very happy about this. The Canadian was most accurate.
2. Unfortunately the trigger did not re-set a single time!
I have chamfered the trigger lever and disconnector edges, perhaps not enough. The trigger lever pin is not original and there is a bit of side-to-side play. Could that also be a problem? What else can I do with the re-setting problem?
Thanks.
jonnyc is offline   Reply With Quote