LugerForum Discussion Forums - View Single Post - Loose front sight insert

Ron Smith · 03-26-2008, 09:02 PM

Jay,

The best way to tighten the dovetail, is to take out the sight.

Find a piece of steel bar stock about 5/8" diameter.

Clamp the barrel firmly in a padded vise.

Lay the bar stock across the top of the dovetail. Be sure that is parallel with the edges of the dovetail and squarely and firmly touching the edges.

Now tap it very lightly with a small hammer. Try the sight for fit.

If it's still loose? Repeat the procedure as needed until the sight resists and has to be drifted into the dovetail.

This method, if done correctly, will upset the dovetail edges without showing signs of peening.

Ron

03-26-2008, 09:02 PM	#2
Ron Smith User Join Date: Feb 2004 Location: Orygun Posts: 4,243 Thanks: 118 Thanked 245 Times in 150 Posts	Jay, The best way to tighten the dovetail, is to take out the sight. Find a piece of steel bar stock about 5/8" diameter. Clamp the barrel firmly in a padded vise. Lay the bar stock across the top of the dovetail. Be sure that is parallel with the edges of the dovetail and squarely and firmly touching the edges. Now tap it very lightly with a small hammer. Try the sight for fit. If it's still loose? Repeat the procedure as needed until the sight resists and has to be drifted into the dovetail. This method, if done correctly, will upset the dovetail edges without showing signs of peening. Ron __________________ I Still Need DWM side plate #49... if anyone runs across a nice one. What ~Rudyard Kipling~ said...