LugerForum Discussion Forums - View Single Post

dalep38 · 03-12-2008, 09:58 PM

Gentlemen : I have a Luger tool that seems proper Thickness which would be under 1/10 of an inch and the marks are 7 above hole and U below the hole ,no other marks present . I have been looking in several books and can't find the clue to the Luger it is for, unless this is some type of unit marking or something like that for a commercial Luger used by some group maybe? Any help would be greatly appreciated. I will post pictures if interest warrants it. Thank You, Dale

03-12-2008, 09:58 PM	#1
dalep38 Lifer Lifetime Forum Patron Join Date: Feb 2008 Location: Southeast USA Posts: 60 Thanks: 5 Thanked 3 Times in 2 Posts	I.D. tool marked 7above & U below hole Gentlemen : I have a Luger tool that seems proper Thickness which would be under 1/10 of an inch and the marks are 7 above hole and U below the hole ,no other marks present . I have been looking in several books and can't find the clue to the Luger it is for, unless this is some type of unit marking or something like that for a commercial Luger used by some group maybe? Any help would be greatly appreciated. I will post pictures if interest warrants it. Thank You, Dale __________________ Always looking for early P.38's Original finish collector grade ,Zeros,480,ac only,40 added,ac40,ac41's and mags