LugerForum Discussion Forums - View Single Post - Is there a subtle difference in DWM & Mauser Grip Screws?

Luke · 10-03-2001, 03:22 PM

I tried 3 different Mauser grip screws, removed from Mauser Lugers, in 3 different DWM Lugers. The screws were the same length and appeared to be the same size, but they would only screw into the DWM frame about 1/2 to 1 turn before binding. This was consistent with all of them.

You wrote:

>>

I had the same experience with some repro screws. They would NOT screw into the DWM frame, but they fit the Mauser just fine.

Oh, well.

Thanks for your imputs.

Luke

10-03-2001, 03:22 PM	#8
Luke User Join Date: Jun 2002 Location: NC - USA Posts: 1,239 Thanks: 0 Thanked 19 Times in 7 Posts	HÃ?Â¥kan, the question was about a difference in Mauser & DWM threads. I tried 3 different Mauser grip screws, removed from Mauser Lugers, in 3 different DWM Lugers. The screws were the same length and appeared to be the same size, but they would only screw into the DWM frame about 1/2 to 1 turn before binding. This was consistent with all of them. You wrote: >> I had the same experience with some repro screws. They would NOT screw into the DWM frame, but they fit the Mauser just fine. Oh, well. Thanks for your imputs. Luke