LugerForum Discussion Forums - View Single Post

Quentin · 06-08-2007, 08:42 PM

I'm wondering about this too and glad you mentioned "crush fit", policeluger. I have a receiver and a barrel and can screw the barrel in hand tight to where there is no gap between the mating surfaces of both (can't get even a strand of hair between them). From that point to get the front sight up all the way the barrel must turn another 1/8th inch (about the width of the extractor cut in the receiver).

You sure have to know what you're doing as it must take a lot of force. Not something I would do, I'd break it for sure!

06-08-2007, 08:42 PM	#3
Quentin User Join Date: Apr 2007 Location: NorthWest USA Posts: 124 Thanks: 59 Thanked 11 Times in 4 Posts	I'm wondering about this too and glad you mentioned "crush fit", policeluger. I have a receiver and a barrel and can screw the barrel in hand tight to where there is no gap between the mating surfaces of both (can't get even a strand of hair between them). From that point to get the front sight up all the way the barrel must turn another 1/8th inch (about the width of the extractor cut in the receiver). You sure have to know what you're doing as it must take a lot of force. Not something I would do, I'd break it for sure!