LugerForum Discussion Forums - View Single Post

Ron Wood · 03-19-2007, 03:42 PM

Hi Ron,

How have I been?...as usual, much better than I deserve.

I have a Finnish 125mm barrel Luger and recently acquired a Luger/Lahti holster that has the magazine pouch cut for the Luger magazine button. The Luger has the right grip set up for the unit ID disk, so I am always on the lookout for a disk. Unfortunately, the only ones that show up are blank, and the asking price is over $100. Shoot, I can make a blank disk for ten cents that you couldn't tell from an original.

Hope you can find a "Big Hole" filler. I really like contract Lugers, and a Finn is a "must have" even though it dates post 1918!

Stay well, keep your head down and your powder dry. Best regards,
Ron

03-19-2007, 03:42 PM	#1
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,040 Thanks: 1,106 Thanked 5,257 Times in 1,724 Posts	Hi Ron, How have I been?...as usual, much better than I deserve. I have a Finnish 125mm barrel Luger and recently acquired a Luger/Lahti holster that has the magazine pouch cut for the Luger magazine button. The Luger has the right grip set up for the unit ID disk, so I am always on the lookout for a disk. Unfortunately, the only ones that show up are blank, and the asking price is over $100. Shoot, I can make a blank disk for ten cents that you couldn't tell from an original. Hope you can find a "Big Hole" filler. I really like contract Lugers, and a Finn is a "must have" even though it dates post 1918! Stay well, keep your head down and your powder dry. Best regards, Ron __________________ If it's made after 1918...it's a reproduction