Just FYI... the mag safety was a stamped sheet metal spring... not a machined steel part... while the Henrotin E-book does not give dimensions on the safety, the illustrations are good enough that an enterprising machinist like your self could probably make a good reproduction from the images... They would be a novelty, but I think you would probably sell a few here on the forum if you could make them... If you are concerned about someone passing them off as genuine, you could just mark them in a way that they could never be mistaken for a genuine part...
Just my $0.02 Welcome to the Lugerforum!
__________________
regards, -John S
"...We hold these truths to be self-evident that ALL men are created EQUAL and are endowed by their Creator with certain UNALIENABLE rights, and among these are life, LIBERTY, and the pursuit of happiness..."
|