LugerForum Discussion Forums - View Single Post - WTK the trick to getting the disassembly lever back in

minigun · 07-30-2006, 02:37 PM

Thanks Howard. Yes, I was refering to the "take down lever". I pulled it out just for a little cleaning and then didn't know it would take a lot to get it back in. I stayed away from the actual lever of the piece as I figured it wouldn't take much to bend or break it. I was able to put a whole lot of pressure on the actual "arm" of the lever (inside the receiver) with a piece of plastic (so not to marr anything and to get good leverage) and I pushed it inward. It then snaped back into place. I thank you for your number for the walk through also. Whew! Like I said, I aint do'in that again!

07-30-2006, 02:37 PM	#4
minigun User Join Date: Nov 2002 Location: Texas Posts: 424 Thanks: 16 Thanked 20 Times in 15 Posts	Thanks Howard. Yes, I was refering to the "take down lever". I pulled it out just for a little cleaning and then didn't know it would take a lot to get it back in. I stayed away from the actual lever of the piece as I figured it wouldn't take much to bend or break it. I was able to put a whole lot of pressure on the actual "arm" of the lever (inside the receiver) with a piece of plastic (so not to marr anything and to get good leverage) and I pushed it inward. It then snaped back into place. I thank you for your number for the walk through also. Whew! Like I said, I aint do'in that again!