LugerForum Discussion Forums - View Single Post

07-15-2006, 07:46 PM

Maybe the end of the hanger could be made in a Y shape and then weld in two spots above the serial number and on either side of the slot where the take down lever is located. This would be two smaller welds. A thought anyway.

07-15-2006, 07:46 PM	#5
RGARRETT Guest Posts: n/a	Maybe the end of the hanger could be made in a Y shape and then weld in two spots above the serial number and on either side of the slot where the take down lever is located. This would be two smaller welds. A thought anyway.