LugerForum Discussion Forums - View Single Post

shadow · 05-02-2006, 11:54 PM

I installed a Wolff mainspring for the first time today. It took about fifteen minutes to install the 36 lb. spring. I tried to follow Thorâ??s directions but whenever I tried to start the main spring into the frame (step 6); the guide rod would come unhooked from the mainspring. In the end I wound up compressing the spring in the frame. Is there a trick to step 6?

I would think that the Germans did not have people in the Luger factories installing these springs armed with only a drift pin and pair of pliers. I assume that some sort of tool was used. I have read several posts where people mention tools to install mainsprings but no photos are posted. Did the Germans have a main spring installer tool and if so can someone post some photos of one?

Thanks,

Chris

05-02-2006, 11:54 PM	#1
shadow User Join Date: Jan 2006 Location: Down The Shore Posts: 245 Thanks: 1 Thanked 6 Times in 4 Posts	Mainspring install tricks or tool I installed a Wolff mainspring for the first time today. It took about fifteen minutes to install the 36 lb. spring. I tried to follow Thorâ??s directions but whenever I tried to start the main spring into the frame (step 6); the guide rod would come unhooked from the mainspring. In the end I wound up compressing the spring in the frame. Is there a trick to step 6? I would think that the Germans did not have people in the Luger factories installing these springs armed with only a drift pin and pair of pliers. I assume that some sort of tool was used. I have read several posts where people mention tools to install mainsprings but no photos are posted. Did the Germans have a main spring installer tool and if so can someone post some photos of one? Thanks, Chris