LugerForum Discussion Forums - View Single Post

G.T. · 08-10-2001, 10:56 AM

as the excess movement will have less effect on accuracy, then it will have on consistant trigger pull, and quite possibly safty! The trigger/lever/trigger bar/disconector assemblies look like they have a lot of excess movement, but in reality, they actually have a close timing/working tolerance.....a few thousands of movement in the sideplate can cause a serious malfunction of these parts, I can't even imagine what .060" movement in this area would do....quite awhile back we had this discussion about tight lockup, and receiver to frame play....I think the most felt that tight is right, for the gun your going to shoot! Good luck, till later....G.T.

08-10-2001, 10:56 AM	#4
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,541 Thanks: 1,342 Thanked 3,742 Times in 1,020 Posts	Probably should effect repair's........ as the excess movement will have less effect on accuracy, then it will have on consistant trigger pull, and quite possibly safty! The trigger/lever/trigger bar/disconector assemblies look like they have a lot of excess movement, but in reality, they actually have a close timing/working tolerance.....a few thousands of movement in the sideplate can cause a serious malfunction of these parts, I can't even imagine what .060" movement in this area would do....quite awhile back we had this discussion about tight lockup, and receiver to frame play....I think the most felt that tight is right, for the gun your going to shoot! Good luck, till later....G.T.