LugerForum Discussion Forums - View Single Post

lugerholsterrepair · 03-13-2006, 10:32 AM

Pete, In addition to your..There is a cut on the back panel. The buckle is too large, on original type 2 holsters it is quite small. The belt loops should be slightly staggered. The line of stitching holding in the bottom of the lifting strap is the worst. Lift straps on these were only held in at the top unlike Artilleries which are sewn under the stock block. All in all not a bad one as repro's go.
Jerry Burney

03-13-2006, 10:32 AM	#6
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,133 Times in 1,439 Posts	Pete, In addition to your..There is a cut on the back panel. The buckle is too large, on original type 2 holsters it is quite small. The belt loops should be slightly staggered. The line of stitching holding in the bottom of the lifting strap is the worst. Lift straps on these were only held in at the top unlike Artilleries which are sewn under the stock block. All in all not a bad one as repro's go. Jerry Burney __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."