LugerForum Discussion Forums - View Single Post

Vlim · 02-12-2006, 07:19 AM

Interesting,

I placed a pair of pliers on the bench, used it as a support for a repro loading tool. Placed the spring upright above the loading tool (diameter of tool hole and spring was roughly the same, perfect). Slid a small screwdriver through the hole in the hook en pressed the hook down through the spring and the loading tool hole with two hands. Afterwards, it was just a matter of detaching the loading tool again.

02-12-2006, 07:19 AM	#6
Vlim Moderator Lifetime LugerForum Patron Join Date: Oct 2002 Location: Europe Posts: 5,053 Thanks: 1,036 Thanked 3,990 Times in 1,205 Posts	Interesting, I placed a pair of pliers on the bench, used it as a support for a repro loading tool. Placed the spring upright above the loading tool (diameter of tool hole and spring was roughly the same, perfect). Slid a small screwdriver through the hole in the hook en pressed the hook down through the spring and the loading tool hole with two hands. Afterwards, it was just a matter of detaching the loading tool again.