Take down lever
 

The take down lever on my DWM 1920 commercial will fall out on it's own. Looking inside the hole there is a very small curved part that upon removal seems worn. Is there replacement part? Or, can I tweak it some making the curve more pronounced?
Thanks

You can try bending it a touch if it is not broken. Tom Heller should have replacements, or someone either here, or Ebay.

Tom is my hero a time or two!

You really don't have to post the same question on both forums.
See my answer(and others) on your other thread.

You can try bending and reanealing your old spring, but if that fails, I do have new German made one available @$25 postpaid. TH

Major Tom, I bent one slightly and it made all the difference in properly fitting. Try it. :cheers:

I was not aware that the 2 forums were connected. I was just trying to get the most info possible and did too. Many thanks to all who replied.

Tom Heller is my Hero!

what's the other forum?

Jan's http://luger.gunboards.com/forum.php

They're not connected per se, as they have separate domains and ownership. But you'll find the community is largely made up of the same people on each forum. I typically read both forums but find myself posting almost exclusively on this one for whatever reason. I think it's mainly because I posted here first lol.

There is never enough luger knowledge! Each offers a different perspective of our luger addiction! Eric

which board is more active? Just curious.

Hi, they are both active, with much overlap and some members only at one or the other.

There is a milled away section in the middle of the spring which might look like wear. It is normal.

BTW, I bought the spring off Ebay. Now the lever does not fall out.