How can I safely pull trigger after cocking?
 

I need some help. I just acquired my first Luger, a 1915 DMW. First I pulled back the cocking lever. When I went to release it forward I squeezed the trigger at the same time I slid the lever forward thinking this would keep the trigger from cocking like on my 98K when I close the bolt. But, after I did this and squeezed the trigger I got a dry fire. What am I doing wrong? Any help from you pros would be greatly appreciated.

Re: How can I safely pull trigger after cocking?
 

Hi Sam...


OK - you *almost* have the technique right


Let the toggle go all the way forward - but don't pull the trigger (it will dry fire)..


Next - lift the toggle about 1/3 of the way through it's firing cycle (enough so the breechblock pulls back - but just before you feel the mainspring take effect on the toggle assembly). You will feel a definate "transition" at that point.


Now - with the toggle at that point, squeeze the trigger, and it should release the firing pin.


Once you do it a couple of times - you'll get the feel of the point you need to lift the toggle ears back to release the firing pin safely...


Hope this helps - and post back if this technique doesn't work for you, OK???

Re: How can I safely pull trigger after cocking?
 

Thanks John. I tried your suggestion a few times by pulling the toggle back about 1/3 and depressing the trigger. So far I still don't have the right spot but I will keep practicing. I have been using a dummy round without a primer cap so as not to do much damage.

Hi Sam..!
 

OK - sounds like you may be pulling the toggle up a bit too far?? Try pulling it up/back so that the breechblock moves back only about 1/2 an inch or so. Right about that point, the effort to pull it back farther should be noticibly firmer. Anyway - that's the point you want - just before the toggle pull-back gets firmer...


I like the idea of the dummy round as well - great idea!!


Let us know if it still doesn't work for you, OK???

It Worked!
 

Worked John.Just a 1/2 inch or so and firing pin disengaged.Thanks! Now, second question: When I pull the toggle back and it locks open because there is no bullet in the clip, is there a way to close the toggle without putting a bullet in the clip and letting the toggle cycle the bullet into the chamber. I am sure you have the answer to this one also. Sam

Re: It Worked!
 

Outstanding!!! Glad it worked out..!!!


As for letting the toggle fall with an empty clip - sure.. Just pull the clip out part way or all the way. Then - pull back on the toggle a bit. That will release the hold open (which is held in place with an empty clip) and let the toggle come forward...


Hope This helps!!!

Re: It Worked!
 

Thanks John. It's guys like you that make this hobby so great. Now I can sleep soundly tonight.

Better market that John....
 

better than Unisom!!!!

My Pleasure....
 

There are dozens of folks on this Board who offer their expertise - and you are right there with us, as you share the same passion for these fine firearms...


Welcome to the Forum, Sam..!!!