LugerForum Discussion Forums

LugerForum Discussion Forums (https://forum.lugerforum.com/index.php)
-   Repairs, Restoration & Refinishing (https://forum.lugerforum.com/forumdisplay.php?f=127)
-   -   Magazine Pin (https://forum.lugerforum.com/showthread.php?t=20637)

MCNJ 12-09-2008 06:07 PM

Magazine Pin
 
I have a mismatched #780 wood mag that is with my 1918 Erfurt. The pin that hold the wood end was makeshift and loose. The holes may even be a bit larger from this......Any ideas on where to get a pin, and are they peened over when installed or a press fit?

I may need to get an oversized pin if the original is too small for a press fit.
Appreciate your help

Mike

Ingvarg 12-10-2008 02:57 AM

Drill the hole out with a drill bit little larger the worn out hole and then cut the end of the drill and you get a perfect pin with a perfect fit.:thumbup:

MCNJ 12-10-2008 08:02 AM

Ingvar
Thanks.......I will work on it later


All times are GMT -4. The time now is 03:12 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2025, Lugerforum.com