parts source for Stoeger 9mm Lugers
 

A friend has a Stainless Stoeger American Eagle Kuger that shows signs of damage to both the inside of the side plate and also to the trigger. Are there any sources of parts for these?
Thanks;
David Uden

It's best to fit a new luger between the grip screws.

These particular guns are not known for their quality and durability and finding correct parts could be difficult. The steel used is too soft and the final fitting is usually poor, causing all sorts of problems.

In the links and resources section there is some contact information...
R.E. Romo, Orimar Corp, PO box 8767, Houston,TX 77249-8767, (713) 305-8540
Current Reproduction Stainless Steel Lugers (Former producer of Mitchell, Stoeger and AIMCO Stainless Steel Lugers)

Not sure if it is current or not. It would probably be best to try and call and see if you can talk to Mr. Romo.

Good luck.

713-305-8540 is the current number, good luck.

I understand that the same number is also used for a FAX if it isn't answered in a few rings. You could also try sending a fax to that number with your request.