"Black Widow" Trigger Plates
I recently purchased a so-called Black Widow, byf, 1941, with matching numbers except for grips and magazine. The bluing is fairly good with some minor wear on the left side of the muzzle and a little less on the right side. The trigger plate shows considerable wear, as might be expected. On closer inspection, I note that the bluing is almost non-exitant on the entire trigger plate, not just on the high points where one would expect wear. Is this normal, or does this suggest a retrofitted trigger plate?
Thanks for any help you can provide. |
Re: "Black Widow" Trigger Plates
Luke,
There should be a small number inside the sideplate which will be one digit higher than the first two digits of the serial number of your byf 41 if it is the correct sideplate. |
Re: "Black Widow" Trigger Plates
Johnny,
Thanks for the tip. My serial number is 4605p and the number inside is 47. That's a big help. Luke |
All times are GMT -4. The time now is 02:16 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Lugerforum.com