Best I can get
 

B close up

If you can find a friend with a closeup lens on a camera it would be very helpful. We need to see fine enough detail to determine if the c/N is stamped, engraved, or pantographed.

--Dwight

Try this
 

See if any better

So apparently it does have hold open latch , spring it flattened.

Very much better, thank you. Good enough to see that the c/N and barrel serial numbers are clearly pantographed. Authentic proof marks and serial numbers are stamped, without exception.

Also glad to see the witness mark, notice that the barrel flange is slightly smaller than the receiver, and the witness mark itself is a hash of strikes, neither characteristic of DWM "fit andf finish."

--Dwight

So what do we have here?
A re barreled p08 short frame , value?

Thank you all, for your expertise . I have withdrawn from purchasing this Luger.

is seems like the barrel shoulder flange is very thick. is this normal or an indication of a replacement barrel?

Ben,

This is an aftermarket, not quite finished barrel that someone placed on the gun and force matched with spurious barrel markings.

You are correct in that the flange is too thick.

Had I known you were in Miami , Alanint . I would have had you inspect it.
I am in Miami Beach.

I would have been glad to take a look, although I am no expert.