Bauer .25 auto...Hey! I got it working

Stevie · 12-21-2003, 01:27 PM

It doesn't look too hard to do. I guess the pin to remove is the little one visable below the frame in the trigger(don't have to remove the trigger or trigger pivot pin?),square headed plunger and spring should pop out. Do you need to pull up on the trigger lever(thingy that pushes the lever in the slide) or remove it to let the plunger out? I got my skinny roll pin punch, tiny ballpeen hammer, and wood block ready( and my exploded parts picture).

Thanx, Stevie.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-21-2003, 01:27 PM	#5
Stevie User Join Date: Aug 2002 Location: Ok. Posts: 212 Thanks: 0 Thanked 0 Times in 0 Posts	It doesn't look too hard to do. I guess the pin to remove is the little one visable below the frame in the trigger(don't have to remove the trigger or trigger pivot pin?),square headed plunger and spring should pop out. Do you need to pull up on the trigger lever(thingy that pushes the lever in the slide) or remove it to let the plunger out? I got my skinny roll pin punch, tiny ballpeen hammer, and wood block ready( and my exploded parts picture). Thanx, Stevie.