Occasional failure to fire

unspellable · 08-02-2004, 06:35 PM

Before you start modifying anything, check to make sure the disconnector is working properly. I had a problem of this sort in which the disconnector occasionaly failed to re-connect after releasing the trigger. This could be a sticky disconnector but in my case proved to be a misfitted trigger lever. There is a little ramp on the upper end of thee trigger lever the disconnector rides up on and it hung up at that point.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-02-2004, 06:35 PM	#3
unspellable User Join Date: Jun 2002 Location: Iowa Posts: 769 Thanks: 0 Thanked 20 Times in 12 Posts	Before you start modifying anything, check to make sure the disconnector is working properly. I had a problem of this sort in which the disconnector occasionaly failed to re-connect after releasing the trigger. This could be a sticky disconnector but in my case proved to be a misfitted trigger lever. There is a little ramp on the upper end of thee trigger lever the disconnector rides up on and it hung up at that point.