A Learning Experience...

Ron Wood · 03-01-2003, 10:15 PM

Heinz,
If you re-read my original post, I stated "When the barrel is machined, the front sight block is broached from the forward barrel band and then a mark is struck on the rear flange exactly 180Ã?Âº from the vertical mid-line of the sight block (or exactly perpendicular to the horizontal plane of the sight block if you want to look at it that way)". I was trying to indicate that the mark was struck as a reference after the front site block was machined, not before.

03-01-2003, 10:15 PM	#1
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,051 Thanks: 1,124 Thanked 5,287 Times in 1,728 Posts	Heinz, If you re-read my original post, I stated "When the barrel is machined, the front sight block is broached from the forward barrel band and then a mark is struck on the rear flange exactly 180Ã?Âº from the vertical mid-line of the sight block (or exactly perpendicular to the horizontal plane of the sight block if you want to look at it that way)". I was trying to indicate that the mark was struck as a reference after the front site block was machined, not before. __________________ If it's made after 1918...it's a reproduction

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode