Take Down Tool Hole <img BORDER="0" src='http://boards.rennlist.com/luger/pic.gif'> - LugerForum Discussion Forums

, Collector Forums" /> Lugerforum Archive" /> Take Down Tool Hole <img BORDER="0" src='http://boards.rennlist.com/luger/pic.gif'> - LugerForum Discussion Forums

LugerForum Discussion Forums

my profile | register | faq | search
upload photo | donate | calendar

		LugerForum Discussion Forums > Luger Discussion Forums > Lugerforum Archive
Take Down Tool Hole

Mark Forums Read

Prev

Previous Post

Next Post

Next

04-24-2001, 04:29 PM	#18
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,156 Thanks: 3,003 Thanked 2,309 Times in 1,098 Posts	Tom? What is an easier way to improve locking fit? Knowing how difficult it is to fit a new sideplate, how would you improve fit of the trigger control components easier than stabilizing the installed sideplate with a setscrew through the lever end? The only way my tired mind can see would be by swapping of components until you got a good fit, (assuming that you had a pool of parts to try...)

Previous
left arrow key Next
right arrow key Close Move

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is Off HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 10:12 AM.