Help Identifying a "Blank: Luger?

Karl · 10-15-2024, 09:11 AM

David,

Good observation about the receiver being proud of the frame.

There is also a cut in the receiver, just behind the barrel, visible on both sides, that would correspond with the correct length of the receiver. I have remained quiet regarding this Luger because I am not an expert. However, my opinion is that the "5" stamped on parts, some in odd locations (sear bar, double stamp on side plate, inside front toggle link), is a red herring. I think that the gun was assembled from partly unfinished/rejected parts - a "lunch box special."

KFS

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

10-15-2024, 09:11 AM	#1
Karl Lifer - Twice Over Lifetime Forum Patron Join Date: Jun 2002 Location: Savannah Posts: 533 Thanks: 0 Thanked 285 Times in 125 Posts	David, Good observation about the receiver being proud of the frame. There is also a cut in the receiver, just behind the barrel, visible on both sides, that would correspond with the correct length of the receiver. I have remained quiet regarding this Luger because I am not an expert. However, my opinion is that the "5" stamped on parts, some in odd locations (sear bar, double stamp on side plate, inside front toggle link), is a red herring. I think that the gun was assembled from partly unfinished/rejected parts - a "lunch box special." KFS