LugerForum Discussion Forums my profile | register | faq | search
upload photo | donate | calendar

Go Back   LugerForum Discussion Forums > Luger Discussion Forums > Swiss Lugers

Reply
 
Thread Tools Display Modes
Unread 07-16-2019, 03:55 PM   #1
Doubs
User
 
Doubs's Avatar
 
Join Date: Jun 2002
Location: Byron, Georgia
Posts: 1,753
Thanks: 849
Thanked 1,827 Times in 601 Posts
Default

If you reload, I STRONGLY suggest using an 86 ~ 90 grain bullet with a cannelure. The short neck of the 30 Luger case may not have sufficient neck tension to prevent the bullet being driven back deeper as it strikes the feed ramp. Thus crimping the case mouth into the cannelure is necessary.

I use .308" 86 grain soft point bullets and 90 grain Hornady .312" XTP HP bullets run through a .310" sizing die. Also, 90 grain Sierra HCSP .312" bullets also run through a .310" sizing die work well but are much more expensive than the XTP bullets.

A good starting load is any of the above bullets over 5.0 grains of Hodgdon CFE Pistol powder. I also chamfer the case mouth to prevent shaving the sides of the bullets.

I have an old take-off 30 caliber Luger barrel that I use to check every round to make sure they chamber properly.
Doubs is offline   Reply With Quote
Unread 07-16-2019, 04:44 PM   #2
rhuff
Patron
LugerForum
Patron
 
rhuff's Avatar
 
Join Date: Mar 2011
Location: Az.
Posts: 2,316
Thanks: 2,768
Thanked 1,000 Times in 735 Posts
Default

My 30 Luger handguns function fine with the Fiocchi factory IF I use the FMJ, and not the soft point ammo. I have been handloading this brass for many years, and have loaded a fair amount of the 85gr .308in. FMJ bullets, but am not pleased with the end results, as a whole.

I have had my best results with 92gr .311in. lead RN bullets, and 92gr .309in. FMJ bullets. I load them behind a full load of Unique Powder and apply a good crimp with a Lee factory crimp die. This combo works extremely well in all of my 7.65P caliber handguns.....not just my Lugers.


I have no idea what reloading components are available to you, so it is hard to recommend components that I have no history with.
__________________
Need DWM breechblock #21
rhuff is offline   Reply With Quote
The following member says Thank You to rhuff for your post:
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:27 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2026, Lugerforum.com