My Luger --41 byf

Frank · 11-07-2002, 11:40 PM

Integral, the numbers are stamped on the inside surface. It would consist of the last two digits "04" of the serial number and maybe also an inspection stamp. The inspection may be small and faint. In your case it would be an eagle-over-655, the same as the inspection marks on the receiver. The right side grip is much stronger than the left grip, with fewer obstructions to get around. I would recommend that if you want to check the grips, remove the right side and examine it. In many cases if you drop the magazine, you can see the back side of the left grip through the frame well enough to spot any numbers present. Good Luck !!!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11-07-2002, 11:40 PM	#15
Frank RIP Patron LugerForum Patron Join Date: Jun 2002 Location: Hot & Dry PHX, AZ Posts: 2,078 Thanks: 24 Thanked 166 Times in 87 Posts	Integral, the numbers are stamped on the inside surface. It would consist of the last two digits "04" of the serial number and maybe also an inspection stamp. The inspection may be small and faint. In your case it would be an eagle-over-655, the same as the inspection marks on the receiver. The right side grip is much stronger than the left grip, with fewer obstructions to get around. I would recommend that if you want to check the grips, remove the right side and examine it. In many cases if you drop the magazine, you can see the back side of the left grip through the frame well enough to spot any numbers present. Good Luck !!!