30 luger snap caps

flydive · 06-28-2018, 05:26 AM

I made my own.

Used old casing, removed the spent primer.
Filled half of the casing with hot glue, then filled the primer space again with hot glue.
When cold trimmed away the excess glue primer side to make it flush.
Added a 3d printed bullet. You could use a normal bullet, but I like the red, plastic one for added safety(no mix up)

when the "primer" is damaged by the pin hitting, takes quite a few, just add more glue and trim

BogeyB · 06-30-2018, 07:40 PM

You can try these folks, and fill the primer pocket with silicone sealer.

Mike

https://www.dummybullet.com/pistol%20calibers.html

06-30-2018, 07:40 PM	#2
BogeyB Lifer Lifetime Forum Patron Join Date: Jul 2003 Location: Mc Donough, GA. Posts: 422 Thanks: 0 Thanked 227 Times in 99 Posts	You can try these folks, and fill the primer pocket with silicone sealer. Mike https://www.dummybullet.com/pistol%20calibers.html __________________ MAGA Always!! NRA Benifactor, GCA

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

06-28-2018, 05:26 AM	#1
flydive User Join Date: Feb 2015 Location: Switzerland Posts: 63 Thanks: 1 Thanked 45 Times in 23 Posts	I made my own. Used old casing, removed the spent primer. Filled half of the casing with hot glue, then filled the primer space again with hot glue. When cold trimmed away the excess glue primer side to make it flush. Added a 3d printed bullet. You could use a normal bullet, but I like the red, plastic one for added safety(no mix up) when the "primer" is damaged by the pin hitting, takes quite a few, just add more glue and trim