Luger Steel Lanyard 'Staple' - LugerForum Discussion Forums

04-07-2017, 12:22 PM

#20

wlyon

Lifer 2X
Lifetime Forum
Patron

Join Date: May 2005

Location: Somewhere in Montana

Posts: 2,676

Thanks: 3,247

Thanked 2,670 Times in 991 Posts

Here is an original lanyard loop. I think they were pressed in and then the protruding ends ground or machined off. I removed one years ago just as stated by GT, with a small punch. . Inserting was more difficult because of the tight fit. I used a small nylon hammer and slowly tapped both sides in. Bill

Attached Images

IMG_1222[1].JPG (76.5 KB, 363 views)

__________________
Bill Lyon

The following 4 members says Thank You to wlyon for your post:

cirelaw, ithacaartist, mrerick, sheepherder

Previous
left arrow key Next
right arrow key Close Move

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 12:33 PM.