P 08 frames transferred from DWM/BKIW to Mauser in 1930; and other frame variants too

Mark1 · 01-20-2016, 06:51 PM

OK, that works!

So my 1930 ,06 Waffenfabrik Bern is a Type 3 "new model long frame" (thanks Ron Wood)

The new model short frame (original P08) = 129mm , plus 1mm at the front (long frame), plus 1mm at the rear (toggle pin solution) = 131mm. Which is what I measure.

Not trying to derail this discussion of DWM and Mauser frames just understanding how this toggle pin problem was addressed by the "other" Luger manufacturer of the time.

Mark

01-20-2016, 06:51 PM	#1
Mark1 User Join Date: May 2008 Location: New Zealand Posts: 72 Thanks: 332 Thanked 74 Times in 25 Posts	OK, that works! So my 1930 ,06 Waffenfabrik Bern is a Type 3 "new model long frame" (thanks Ron Wood) The new model short frame (original P08) = 129mm , plus 1mm at the front (long frame), plus 1mm at the rear (toggle pin solution) = 131mm. Which is what I measure. Not trying to derail this discussion of DWM and Mauser frames just understanding how this toggle pin problem was addressed by the "other" Luger manufacturer of the time. Mark Last edited by Mark1; 01-20-2016 at 06:52 PM. Reason: add Type 3

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode