New Project! For shooters!

[Lugerdoc]

GT. You will probably want to do some investigating of some modified recoil springs, since the heavier the barrel, a lighter recoil spring will be required for full recoil of the toggle assy. in the case of the GPC 16+ inch "carbine" barrel, a one piece recoil spring with about 14 turns will allow full recoil, but doesn't have enough strength to return the toggle and load the next round. Perhaps a dual spring system, as in the Radom, Glocks, etc may be the answer. TH

[G.T.]

Hi Ed! As this was/is a proto. we are mainly tying to establish what we can and can not do, both with economy of labor, and tools / materials.... Nothing is ruled out, but some secondary operations are as time consuming as the complete job all together? But, my plan is to have the front sight base relief cut radius, start slightly back from the muzzle... That way, I can chamfer the diameter, and recess / counter bore the full dia. of the muzzle, everything else remain the same? Stability for this cut may be an issue that will give us trouble.... We might /will find that out on number two! ..........First, we finish number one!...... best to all, til...lat'r...GT....