Feeding problem

mrerick · 04-05-2015, 03:02 PM

Check to see how high the magazine has latched into the frame. If there is a lot of play it could be shifting down too low during cycling.

The issue could also be the magazine spring. Don't try to disassemble it yourself. People that work on these (Like G.T. on this board) have special tools.

Finally, consider that the recoil spring could be a 21 turn rather than a 17 turn spring. This could have too much power, and cause the cycle timing to be off.

04-05-2015, 03:02 PM	#5
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,925 Thanks: 1,377 Thanked 3,140 Times in 1,520 Posts	Check to see how high the magazine has latched into the frame. If there is a lot of play it could be shifting down too low during cycling. The issue could also be the magazine spring. Don't try to disassemble it yourself. People that work on these (Like G.T. on this board) have special tools. Finally, consider that the recoil spring could be a 21 turn rather than a 17 turn spring. This could have too much power, and cause the cycle timing to be off. __________________ Igitur si vis pacem, para bellum - - Therefore if you want peace, prepare for war.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode