Broken Extractor... Rebuild or Replace, any recommendations please?

alanint · 11-25-2014, 12:26 AM

If you post the number the old extractor has, one of the parts gurus may be able to replace it with a similarly numbered DWM part for less than what micro welding might cost you.

1917garkunkel · 11-25-2014, 06:22 PM

I've inquired with Microarc, am awaiting a reply. I'll post here when they respond with pricing, feasibility.

In the meantime, that's a good idea to post up a WTB for the numbered part.

I'll look for the area on the forum where that is done, and if anybody here has a #37 extractor lying about... holler!
-R

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

11-25-2014, 12:26 AM	#1
alanint User Join Date: Mar 2008 Location: Marco Island, Florida Posts: 4,867 Thanks: 1,685 Thanked 1,917 Times in 1,193 Posts	If you post the number the old extractor has, one of the parts gurus may be able to replace it with a similarly numbered DWM part for less than what micro welding might cost you.

11-25-2014, 06:22 PM	#2
1917garkunkel User Join Date: Nov 2014 Posts: 15 Thanks: 0 Thanked 3 Times in 1 Post	I've inquired with Microarc, am awaiting a reply. I'll post here when they respond with pricing, feasibility. In the meantime, that's a good idea to post up a WTB for the numbered part. I'll look for the area on the forum where that is done, and if anybody here has a #37 extractor lying about... holler! -R