Luger Failure to feed

spacecoast · 10-03-2014, 10:40 AM

There's a pin that holds the extractor in the breech block. The pin can be carefully drifted out and then you can remove the extractor and clean thoroughly. There's often a lot of dirt in and around it. If the extractor spring will come out, remove it as well and clean thoroughly.

fwm · 10-03-2014, 11:01 AM

OK I will try that first. Thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

10-03-2014, 10:40 AM	#1
spacecoast User Join Date: Dec 2013 Location: FL and PA Posts: 332 Thanks: 276 Thanked 243 Times in 109 Posts	There's a pin that holds the extractor in the breech block. The pin can be carefully drifted out and then you can remove the extractor and clean thoroughly. There's often a lot of dirt in and around it. If the extractor spring will come out, remove it as well and clean thoroughly.

10-03-2014, 11:01 AM	#2
fwm User Join Date: Feb 2014 Posts: 7 Thanks: 0 Thanked 0 Times in 0 Posts	OK I will try that first. Thanks