Dovetail cutter???

[G.T.]

Yes, beyond my experience as well... but, I think a big massive broach with the dove tail cut on the length face could be used on a very fast production scale... just too much leisure time is my excuse! .........til..lat'r...GT

[Olle]

Originally Posted by G.T.

Yes, beyond my experience as well... but, I think a big massive broach with the dove tail cut on the length face could be used on a very fast production scale... just too much leisure time is my excuse! .........til..lat'r...GT

When I was experimenting with the sight leveling tool, I realized that the size of the dovetail can vary well beyond the tolerances for a press fit. I can't remember how much of a taper I put on it (3-4/1000" in 4"?), but it was still just barely enough for the barrels I tried it on.

I'm not sure how they solved this in the factories, but one or two quick strokes with an angled file would cut a taper wide enough to start the sight blade. This is what I would do for a DIY job, and it might be what they had to do in the factories as well. Unless it's the sight blade being tapered... It's kind of difficult to measure, so I don't know for sure.