![]() |
my profile |
register |
faq |
search upload photo | donate | calendar |
|
|
|
|
#1 | |
|
User
Join Date: Jul 2003
Location: New York, NY
Posts: 1,579
Thanks: 2,154
Thanked 402 Times in 251 Posts
|
Quote:
I'm happy you are enjoying your Luger and that it is now functioning properly for you!!! Some of the problems you experienced with your Interarms Parabellum are a bit puzzling to me, but, on the other hand, I'm not one to argue with success. Original recoil springs on these were quite strong from the factory; as were the magazine springs, that were timed to the recoil springs. If, as you say, you can easily pull your magazine spring down for the eighth round, with your bare thumb, there is something very, very wrong with your magazine spring. Your C.O.A.L. figures are totally puzzling to me; as your round nose bullets, if you are loading and shooting from a fully loaded 8 round magazine, should jam like the Devil at that short of length. The well established C.O.A.L. for round nose bullets is 1.173 inches and has been since the introduction of the Luger, per original German DWM and Mauser sources. Also, for future bullet types, you may wish to read my sticky "Determining Proper Cartridge O.A.L", as it may be helpful. I fully agree that Lugers prefer slower powders, as my most accurate and reliable powders are in the exact same burning range as your Winchester Auto Comp powder. Lugers do not prefer "Hot Loads" as you can now also attest. I've also experience week extractor spring problems; which, by the way, is one of the major causes of "smoke stacks" in a Luger. Again, good luck shooting your very fine Interarms Parabellum!!! Sieger Last edited by Sieger; 03-05-2014 at 03:17 PM. |
|
|
|
|
|
|
#2 |
|
Patron
LugerForum Patron Join Date: Mar 2011
Location: Az.
Posts: 2,316
Thanks: 2,768
Thanked 1,000 Times in 735 Posts
|
Thank you for posting your problems and solutions. All of us "Luger folks" realize that (1) every Luger is an individual (2) a luger is sensitive to both springs(balance) and ammo. I am glad for you that you can now fully enjoy your Mauser Parabellum. I own an 06/73 6in. bbl. in 9mm that was NIB when purchased. It is a shooter for me, as I am no longer a collector of anything, except arthritis!!
The original mags that came with my 06/73 have a super strong spring. Without a loading tool, I can not load 5 rounds....perhaps I am a weenie. I also load my 9mm rounds with a medium burn powder, that being Power Pistol and Unique. I have stayed with a longer OAL than what you describe, but one can not argue with success. My extractor and spring are functioning fine.......at least they seem to be. Again, glad to hear that you have hit the "sweet spot" for your Luger and 100% reliability....Congrats. |
|
|
|
| The following member says Thank You to rhuff for your post: |
|
|
#3 | |
|
User
Join Date: Jul 2003
Location: New York, NY
Posts: 1,579
Thanks: 2,154
Thanked 402 Times in 251 Posts
|
Quote:
My most accurate FMJ 9mm load is: WW Commercial Cases Remington 1 1/2 Primers Hornady 124 gr. FMJFP O.A.L. 28.7mm Power Pistol at 5.4 grs. Good shooting!!! Sieger Last edited by Sieger; 03-11-2014 at 11:52 AM. |
|
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|