Can anyone tell me more about this flash hider and takedown tool?

Ron Wood · 12-06-2013, 12:00 PM

Only partially correct John. The OD of the 4mm adaptor that goes with this muzzle device is 9mm, so the hole is large enough. But without the insert adaptor the alignment is not precise so you are correct that firing a 9mm round through it would most likely be a very unpleasant experience.

At any rate, calling this device a flash hider is ridiculous but Simpson's isn't the only party guilty of this misnomer.

12-06-2013, 12:00 PM	#6
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,051 Thanks: 1,124 Thanked 5,287 Times in 1,728 Posts	Only partially correct John. The OD of the 4mm adaptor that goes with this muzzle device is 9mm, so the hole is large enough. But without the insert adaptor the alignment is not precise so you are correct that firing a 9mm round through it would most likely be a very unpleasant experience. At any rate, calling this device a flash hider is ridiculous but Simpson's isn't the only party guilty of this misnomer. __________________ If it's made after 1918...it's a reproduction

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode