![]() |
my profile |
register |
faq |
search upload photo | donate | calendar |
|
|
|
|
#1 | |
|
Lifer
Lifetime Forum Patron Join Date: Feb 2009
Location: ...on the 'ol Erie Canal...
Posts: 8,208
Thanks: 1,425
Thanked 4,474 Times in 2,343 Posts
|
Quote:
But it's what I got. The Forster case trimmer is very nice. I've had this one since the '70's...When I bought the new RCBS Rockchucker reloading 'kit' from a GB seller several years ago, it came with the RCBS case trimmer. I've never used the RCBS because I got used to this one, and have several pilots and reamers for it. I think I have another collet too. ![]() Does your drill attachment have a 'flex' joint, or a universal of some kind??? (I used to have a drill like that...Inherited from my father)...
__________________
I like my coffee the way I like my women... ...Cold and bitter...
|
|
|
|
|
|
|
#2 |
|
Lifer
Lifetime Forum Patron Join Date: Feb 2009
Location: ...on the 'ol Erie Canal...
Posts: 8,208
Thanks: 1,425
Thanked 4,474 Times in 2,343 Posts
|
I thought it was in this thread, but I don't see it...Anyway, someone commented on milling the bullets instead of drilling them...I couldn't do that with the drill fixture (holes are too deep) so I made a new fixture...
Two strips of 3/8" aluminum drilled & pinned and then top & bottom milled flat. Four 5/16" holes drilled with a .022" plastic strip as spacer between them, to allow for clamping. Fixture with four .110" dia M1 Carbine bullets clamped in position. I milled every .020" and weighed between cuts. The final measurement was .115" to get a ~86gr bullet. Final weighing before starting run. 86.2grs...Close enough! Comparison of 85gr Tokarev bullet, my shaved 86gr carbine bullet, and 110gr carbine bullet. I chamfered the bottom edge with a file to ease loading, but I think I will make a 'cap' that will press a round edge on the bottom... I also want to make a run of 95gr cut-down carbine bullets...
__________________
I like my coffee the way I like my women... ...Cold and bitter...
|
|
|
|
|
|
#3 |
|
Lifer
Lifetime Forum Patron Join Date: Feb 2009
Location: ...on the 'ol Erie Canal...
Posts: 8,208
Thanks: 1,425
Thanked 4,474 Times in 2,343 Posts
|
Ran some more Midway .308" dia 30 Carbine FMJ bullets through the mill today...Made these ~93gr, for the Luger...
I'll call these milled bullets 'shavetails'... ![]() First two are 'shavetails', last is OEM Midway 30 Carbine... For more comparison, a Sierra .308"/85gr was .536" OAL, and a Tokarev 'pull' was .307"/85gr and .542" OAL... I thought I had a 5/16" radiused edge end mill, but I can't find it, so I'll have to make do with a chamfered-by-file base on my 'shavetails'...
__________________
I like my coffee the way I like my women... ...Cold and bitter...
|
|
|
|
| The following member says Thank You to sheepherder for your post: |
![]() |
| Tags |
| blivet |
| Thread Tools | |
| Display Modes | |
|
|