TargetLuger project - LugerForum Discussion Forums

05-20-2013, 01:39 PM

Spuhr

User

Join Date: May 2013

Posts: 32

Thanks: 0

Thanked 193 Times in 24 Posts

I really wanted an adjustable sight, and previously I have seen that no adjustable sights really seems to survive the violence on the rear toggle in the long run.
So here is the new manufacured toggle.
Starting with a piece of Uddeholm Calmax steel hardened to 50 HRC.
Hardening is done in a furnace in 960 degrees celcius.

Attached Images

	New toogle.jpg (84.0 KB, 140 views)
	Hardning.jpg (82.4 KB, 124 views)
	Cut togle.jpg (58.0 KB, 129 views)
	466560_362882670495968_282514696_o.jpg (74.1 KB, 121 views)
	Virecutting.jpg (113.1 KB, 125 views)
	Grinding toogle.jpg (97.5 KB, 130 views)
	Fitting toogle.jpg (60.8 KB, 151 views)
	Rear toogle.jpg (115.3 KB, 132 views)
	rear toogle from front.jpg (94.2 KB, 143 views)
	rear toogle from rear.jpg (107.0 KB, 147 views)

The following 5 members says Thank You to Spuhr for your post:

cirelaw, John Sabato, lfid, Michael Zeleny, RAY1946

Previous
left arrow key Next
right arrow key Close Move

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 12:00 PM.